防火卷簾門是現代高層建筑中不可缺少的防火設施，除具備普通門的作用外，具有防火、隔煙、抑制火災蔓延、保護人員疏散的特殊功能，廣泛應用于高層建筑、大型等人員密集的場合。下面濟南防火卷簾門安裝維修人員來講講防火卷簾門的幾種情況的調試過程。

Fireproof rolling shutter door is an indispensable fire prevention facility in modern high-rise buildings. In addition to the function of ordinary door, it has the special functions of fire prevention, smoke separation, fire prevention and evacuation protection, and is widely used in high-rise buildings, large shopping malls and other crowded places. Next, the installation and maintenance personnel of Jinan fireproof rolling shutter door will talk about the debugging process of several situations of the fireproof rolling shutter door.

防火卷簾門正反轉怎么調？

How to adjust the positive and negative rotation of fire shutter door?

防火卷簾門正反轉只需把零線火線交換一下。

The positive and negative rotation of the fireproof rolling shutter door only needs to exchange the zero line and live line.

防火卷簾門在操作運用進程中，操作人員不得私自分開操作地址，應親密留意啟閉狀況和執行狀況，在啟閉時卷簾下面禁絕有人站立、走動。在運用進程中一旦發現異常狀況應立刻接納緊要辦法，割斷輸入電源，掃除毛病。

During the operation and application of the fireproof rolling shutter door, the operator shall not separate the operating address without permission, but shall pay close attention to the opening and closing conditions and execution conditions. No one is allowed to stand or walk under the rolling shutter when opening and closing. In the process of application, once abnormal conditions are found, emergency measures should be taken immediately to cut off the input power supply and eliminate the problems.

防火卷簾門應樹立按期保護準則，并做好每樘卷簾的保護記載任務，立案存檔。長時間不啟閉的卷簾半年需保護一次，內容為消弭塵圾，涂刷油漆，對傳動部分的鏈輪滾子鏈加光滑油生對等。

The fire rolling shutter door shall be protected on schedule, and the protection record task of each rolling shutter shall be completed and filed. The roller shutters that have not been opened and closed for a long time shall be protected once every six months. The contents are to eliminate dust, paint, and add smooth oil to the sprocket roller chain of the transmission part.

防火卷簾的調試具體步驟？

What are the specific steps for debugging the fire shutter?

1、檢查線路正確無誤后接通電源，按手動按鈕盒上的上升鍵，使卷簾運行頂部，然后關閉電源；

1. After checking that the circuit is correct, turn on the power, press the up button on the manual button box to make the roller shutter run to the top, and then turn off the power;

2、中位設置：將SW2撥ON位，打開電源，按停止鍵，卷簾停止并記錄中停位；

2. Middle position setting: turn SW2 to ON, turn on the power, press the stop button, the roller shutter stops and records the middle position;

3、下位設置：按下降鍵，卷簾開始下行，再按下停止鍵或運行低位后，卷簾停止；

3. Lower position setting: press the down key, the roller shutter starts to go down, and then press the stop key or run to the low position, the roller shutter stops;

4、結束設置：關閉電源，將SW2撥回OFF位后重新打開電源，控制器進入正常運行狀態。

4. End setting: turn off the power, turn SW2 back to OFF and turn on the power again, and the controller will enter into normal operation state.

在防火卷簾門運行檢查之前需要注意一下幾個方面，如：通電功能、故障報警功能、消防報警功能、手動控制功能、自動控制功能以及自重下降等功能等。為了，希望大家多關注，來我們這里http://m.luoboyy.com看更多資訊吧！

Before the operation inspection of the fire rolling shutter door, attention should be paid to the following aspects, such as power on function, fault alarm function, fire alarm function, manual control function, automatic control function, dead weight drop and other functions. For safety, I hope you can pay more attention and come here http://m.luoboyy.com Read more!